I play paintball frequently enough that I finally broke down and made myself a paintball gun holder. Is it a requirement for paintball? Of course not! Is it a convenient place to put your gun between games while you fill the hopper and work on it? Yes!
I initially tried a different design but didn’t like it. This was my second attempt and I’m quite pleased with it. I found several youtube videos showing how to make PVC paintball gun holders. They showed what I needed to see, but in almost all of them, the people creating the videos didn’t measure anything – they were just winging it. I’m not one for winging it. So, after successfully building my own, here are detailed instructions.
First, supplies. You’ll need:
- PVC cutting tool (you can use a hacksaw if needed)
- dry erase marker
- ruler or tape measure
- PVC fittings – all in 3/4 inch PVC (unless otherwise indicated):
- 4 – 90 degree elbows
- 4 – 45 degree elbows
- 3 – tees
- 1 – 3/4″ to 1″ tee
- 3/4 PVC pipe cut to the following lengths:
- 1 – 24 centimeter piece (9 1/2 inches)
- 4 – 22 centimeter pieces (8 2/3 inches)
- 1 – 16 centimeter piece (6 1/3 inches)
- 2 – 11 centimeter pieces (4 1/3 inches)
- 4 – 10 centimeter pieces (4 inches)
- 1 – 5.5 centimeter pieces (2 1/4 inches)
- 2 – 4.5 centimeter pieces (1 3/4 inches)
Here’s a photo of all the pieces labeled:
Once you cut all of the pieces of PVC, then it’s just a matter of assembling them in the right way. Here are the pieces assembled and labeled:
The hardest part of this build was cutting the 3/4″ x 1″ tee in half. That isn’t actually required. You could also just use another 3/4″ tee and turn it sideways, placing it under the barrel. If you do, the length of PVC that holds it up will need to be slightly shorter.
3,131 total views, 13 views today